() Our company specializes in repairing broken water pipes, water pipe seepage, water pipe leaks, hidden pipe leaks, bathroom water pipe leaks, cupboard water pipe leaks, exposed water pipe leaks in toilets and bathrooms. How to waterproof and block leaks in toilets and bathrooms? Frequent water use in toilets and bathrooms. If the waterproofing treatment is not done well, water leakage will occur. The main phenomena include dripping water from floor pipes, water accumulation on the ground, damp walls, and water seepage. Even the roof and walls of the lower floor are wet and dripping. To control leakage in toilets and bathrooms, you must first find out the location and cause of the leakage. ． There is water leakage at the connection between the toilet and the drainage pipe. Because the height of the drainage pipe is not enough, the depth of the toilet outlet into the drainage pipe is not enough, and the connection is not filled tightly. The waterproofing treatment in the bathroom is not good. After the toilet is used, water accumulates on the floor and the walls are damp. Even the lower ceiling walls were showing signs of moisture and dripping. ． During construction, water leakage occurred at the entrance of the squat pit water well. The water connection of the squat pit was smashed but was not discovered. The water-filled rubber bowl is not tied properly, or after being tied with iron wire, the iron wire is rusty and broken, and the connection between the rubber bowl and the pit water is broken, causing water to accumulate on the ground after use. The walls are damp, causing dampness and dripping on the lower roof and walls. ． The reason why the sanitary ware is not firmly installed is that the pre-embedded wooden bricks are not branded or not embedded during construction, the sanitary ware is not firmly installed, and the sanitary ware becomes loose and unstable during use, causing damage to the pipe connections or water leakage. ． The elevation of the floor drain drain outlet is incompatible with the elevation of the ground or bathroom equipment, causing flooding and poor drainage of sanitary equipment, causing leakage in the weak parts of the linoleum or causing the linoleum to rot. The height of the upper outlet of the floor casing is too small. , water leaks directly from the casing to the lower roof. ． If there is partial or general leakage in the lower roof, it is recommended that the sleeve felt is partially aged and cracked after the linoleum is finished and the finished product protection work is not done well. In addition, due to the hollowing and cracking of the layer. The pipes passing through the floor slab were not sleeved, and the hole was not properly treated after drilling. Bricks, sawdust and other debris were placed in the wet concrete to block the hole. Cracks occurred at the connection between the hole-blocking concrete and the floor slab, causing the waterproof layer and the leveling layer to be drilled together. Form a water inlet. Water enters the trench layer through defects, causing leaks in the roof. ． The waterproof height is not enough. Moisture spots may appear on the other side of the sanitary duct and flow into or wander around, and even flow along the pipeline interface to the next layer. ． The linoleum is not firmly adhered to the mouth. The mountain appears to be open and warped, or due to local deformation of the base layer, the linoleum flat and facade junctions are broken, resulting in moisture stains or weak flow marks in the upper part of the lower layer and in the drainage field.
Jingtongyuan professional water pipe repair, heating repair, bathroom deodorization, bathroom concealed pipe leakage repair